So if you are not using the default directories (/plugins and /bios) you should use these buttons to change them. Go to Config =>Configure to start configuring PCSX2.You'll see a screen like this (click to enlarge):įirst off you can use the Set Plugins Directory and Set Bios Directory to change the directory from which PCSX2 loads its plugins and bios respectively. This is the main GUI(Graphical User Interface) of PCSX2.From here you can change the settings or plugins used by PCSX2 as you see fit. The new VTLB version of PCSX2 has replaced the 2 older ones, but do note that save states created with the old VM build will not be compatible with it. Plugins available for Linux are: ZeroGS OpenGL, ZeroSPU2, PeopsSPU2, ZeroPad, EFP Iso, EFP Polling and Linuz Iso You need the following installed: gtk2, opengl, libbz2, libjpeg, glew-dev, libxxf86vm-dev, x11proto-xf86vidmodeautomake and autoconf (version >= 1.9) Nvidia Cg-Toolkit, libasound-dev, joystick. To compile from source, follow the instructions in the checkout section, then go to the PCSX2 folder and type "sh build.sh all", and all the plugins with PCSX2 will compile in the bin folder. Get the binary from HERE or the source from GoogleCode. ![]() ![]() Here it is in steps:Ģ) Open the archive and extract its contents into a folder (eg C:\PCSX2)ģ) Run pcsx2.exe which is in the folder you extracted the files. In this guide I will try to explain how to properly configure PCSX2 and to give some tips for running games. The latest configuration guide for v1.0.0 can be found HERE
0 Comments
Leave a Reply. |